How to Fix a Flashing Red Light on Deco
How to Fix a Flashing Red Light on Deco
Blog Article
TP-Link Deco units are equipped with a multi-color LED indicator that helps users quickly identify the system’s status. A flashing red light is a clear indication that there’s a connectivity issue that needs attention. This comprehensive guide will walk you through the possible causes of the red light on your Deco units and offer effective solutions to resolve the issue.
This guide is divided into two main sections: the first addresses issues with the main Deco unit, while the second focuses on the satellite units. You can skip to the relevant section to troubleshoot more efficiently.
Why is Your Deco Flashing a Red Light?
A red blinking light on your Deco mesh unit generally signals a network connectivity issue. When the main Deco flashes red, it usually points to a lack of internet access from the modem. On the other hand, if the satellite Deco units are flashing red, they are likely unable to establish a connection with the main unit.
It’s also possible that the issue stems from your Internet Service Provider (ISP). To rule this out, connect a computer directly to the modem and check if you can access a website or the TP Link Deco setup interface. If successful, proceed with the troubleshooting steps below.
Troubleshooting: Deco Flashing Red Light
Follow these detailed instructions to resolve the red flashing light issue on your TP-Link Deco system.
If the Main Deco Unit is Flashing Red
If the red light appears on the main Deco, begin by inspecting the Ethernet connection between the Deco and your modem:
Ensure the LAN cable is securely connected to LAN Port 1 of the modem and any available Ethernet port on the Deco (operating in router mode).
Check the Ethernet cable for visible damage or cuts.
Confirm that the cable connection is both stable and tight.
Tip: A faulty cable or a loose connection can interrupt communication between the modem and Deco, triggering the red light.
If Satellite Deco Units are Flashing Red
In the event that your satellite Deco units are flashing red, consider their placement in relation to the main unit:
Verify that the satellite units are not too far from the main Deco. Excessive distance can hinder communication between units.
Reposition the satellite units closer to the main Deco to enhance signal strength and connectivity.
If the issue persists, reboot all Deco units to refresh the system and eliminate temporary glitches.
Reposition Deco Units to Avoid Interference
Whether you’re troubleshooting the main or satellite Deco units, poor placement can be a hidden culprit. Avoid setting up Deco units near metal objects, thick walls, or electronic devices that may cause WiFi interference. Relocating the unit to a central, open area can significantly improve connectivity and resolve the red light issue.